Switch Controller Products

 
UP12A    1:2 Uplink Controller

The UP12A can be interfaced with any type of amplifier that provides a dry contact output for fault status. Amplifiers could be HPAs, TWTs, or upconverters …….any redundant amplifier system that operates a switch.

 

Please call for details.

UPL-2    1:1 Redundant Switch Controller 
 
The UPL-2 can be interfaced with any type of amplifier that provides a dry contact output for fault status. Amplifiers could be HPAs, TWTs, or upconverters …….any redundant amplifier system that operates a switch.

 

Please call for details.

 
Supply for switching 20-30V wave guide switch. May be used with any type of switch.....wave guide or coax.

Also can be used for a ganged pair of input/output switches.

 

Please call for details.

DNL-4    1:1 Downlink Redundant Switch Controller

 

The DNL-4 is a 1:1 downlink controller that contains a coax switch, bias tees, and independent power supplies for the amplifiers. 

Please call for details.

 

DNL-5    1:2 Downlink Redundant Switch Controller 

 

The DNL-5 is a 1:2 downlink amplifier controller. 
Each amplifier is powered by its own power supply (24V).  The controller contains 3 LNB power supplies, 1 separate 28V switch power supply (negative common on switches), 1 logic power supply, 2 co-ax switches,

3 bias tees, low power load, universal AC inputs.  TUV approved.   

 

Please call for details.

CM1208    1:1 Uplink Redundant Switch Controller

   -Separate input



Please call for details.

   -Split input

 

Please call for details.


 

 

Please call for details.